Who sells good 7.62x54r dies?

[Montalban]

Who sells good 7.62x54r carbide dies? and is located or ships to canada?

I usually get my stuff off ebay or forums, but cant locate any.

 

[Jarlath]

Buy some Lee dies from Epps or Higginson Powders or you could click on the sponsor's links. They can order for you.

According to Lee's Website,
Pelletier Louis
314 Jean-Proulx
MONTMAGNY, G5V 4A9 CANADA
Phone: 418-248-7176
FAX: 418-247-3972
pellou@guebectel.com

 

[Montalban]

Thanks, I'll try to give him a ring after work.

 

[762shooter]

I use Lee dies but I did have a problem with them. The bottom of the sizing die had too pronounced an edge so that when sizing a case fired in a military chamber this edge scraped the lower inch of the outside of the case. So I took a rubber/abrasive polishing stone in my Dremel tool and and carefully radiused this edge to a nice, even and polished curve. Now it works fine.

 

[Hitzy]

Who sells good 7.62x54r carbide dies? and is located or ships to canada?

I usually get my stuff off ebay or forums, but cant locate any.

You won't find any carbide dies is that caliber. Carbide dies are basically used for straight wall cases and no lubing is required.

 

[Montalban]

You won't find any carbide dies is that caliber. Carbide dies are basically used for straight wall cases and no lubing is required.

crap, I hadn't noticed that. So far, I have only reloaded 38spl and this was to be my first attempt at rifle loading. Ah well, its 1 xtra step. Thanks for the tip though.

 

[Craig67]

Use Higginson's. They are a Lee dealer and have components also.

Make sure you get a .303 British expander if you buy Lee dies. The expander than comes with it is .308.

Craig