AR15 SPR Finished :D
- Thread starter RobertMcC
- Start date
SPRs with PRI tubes and ARMS rails...sooo 2003/2004,
You guys are cute.
Yeah,
Now its the Short Dot craze.
If you don't have one, you are nobody !
Yeah,
Now its the Short Dot craze.
If you don't have one, you are nobody !
Remember this is only 1 of the 3 AR's I own. I got a 14.5" with a ARMS #35 mount with a Simmons 1.5-5x20mm wide angle scope. It's like a Short Dot just as expensive.
That's an airsoft replica Ronin. Look at the receiver logo and crap-tastic scope mount.
It needs a can..and real SPR's have A2 stocks don't they?
But i guess it's just your interpretation of one..Nice rifle
P0WERWAGON
CGN Ultra frequent flyer
- Location
- burnaby BC كافر
i looks like the gas tube through the holes in the handguard.
My bad...
I have a Fake Can coming for my SPR to replace the AK74 brake I had on it...
She shoots awesome, no recoil at all, to be expected, trigger and stock are excellent, I just need to ditch the Versa Pod to get it to be more stable...
LOLSPRs with PRI tubes and ARMS rails...sooo 2003/2004
Well since SOCOM did replace then all with KAC and Larue FF rails..
Seriously I dont know anyone that has had good luck (even civilian shooters) with that combo - I know myself, Ray and a few others could not get to stay tight even with loctite.
I had built one a couple years back, sold it to a board member, I never had any alignment issues or things coming loose. The PRI tube was straight and solid, for aligning the ARMS rail to the PRI:
- loosen the PRI top rail from the handguard (it has sloted holes),
- attach the ARMS to the upper and PRI rail,
- then re-tighten the PRI rail through the holes in the ARMS.
I liked that setup, sold it in a moment of weakness!!
- loosen the PRI top rail from the handguard (it has sloted holes),
- attach the ARMS to the upper and PRI rail,
- then re-tighten the PRI rail through the holes in the ARMS.
I liked that setup, sold it in a moment of weakness!!
Last edited:
