Gunster; I got busy and built one of your adapters for my chargemaster combo, but instead of a 222 case for the inside, I used a 220 Swift case. Real snug fit, no epoxy needed, and the perfect solution for a minor irritation. I dispensed 25 consecutive charges of powder without one that was plus .1gr. I'm thrilled with the simple but effective solution. Regards, Eagleye.
RCBS Chargemaster 1500 Combo
- Thread starter Jarlath
- Start date
I just ordered a Chargemaster from Natchez last week. Hopefully, it'll get here soon as I'm looking forward to using it for some load development I've got planned.
I'd heard of the cluping issue before. Not sure if I understand exactly what theis adapter looks like. A pic would be greatly appreciated for everyone's benefit as well.
I'd heard of the cluping issue before. Not sure if I understand exactly what theis adapter looks like. A pic would be greatly appreciated for everyone's benefit as well.
Eagleye; I will try a 220 Swift case, thanks for the tip. Another reason I used epoxy was to fill the slight gap between the .22 case and the 7mm case mouth which could trap small amounts of the finer grained powders. This is probably not necessary as the fine powders usually feed accurately without the adaptor.
2bad4u2; I will try again to post pics of the adaptor. If you don't see them by this time tomorrow I've given up in frustration.
2bad4u2; I will try again to post pics of the adaptor. If you don't see them by this time tomorrow I've given up in frustration.
Please, don't tell me that!....
I have had stuff stuck at the border for a month or so and other stuff just passes right through like prunes through an elderly person. It's all luck of the draw I figure.
