Brugger + Thomet GHM9 NON-RESTRICTED Barrels at Dlask Arms Corp.

Cost for the barrel conversion is $550 + tax. The hand guard and mounting block system is $349.99 and the CZ Skorpion faux suppressor is $99.99.

There are only 2x of the hand guards available right now so if you want one snap it up....
 
LOL my bad Scots, didn't mean to imply anything at all. I too have been eagerly awaiting for this bad boy and super glad Dlask is taking on this project!

It would be super awesome if they took credit against the barrels (I won't need it anymore personally)... but perhaps let Dlask confirm since I'm just an observer.

Cheers.
 
Wow. That's way ###ier than my basic conversion + fake can from the other guys.

Even with all options included its still cheaper for Dlask to do it.

I may need to buy another! One Glocked and Dlasked out and one stock B&T with non-res!
 
LOL my bad Scots, didn't mean to imply anything at all. I too have been eagerly awaiting for this bad boy and super glad Dlask is taking on this project!

It would be super awesome if they took credit against the barrels (I won't need it anymore personally)... but perhaps let Dlask confirm since I'm just an observer.

Cheers.


No worries good sir.
 
There is one hand guard left. First come, first served so if you want it then get on the blower and call the shop.

As for the original barrel we don't want it, they will be returned to you in the box. If you want to re-install it at a later date that is fine provided you get it verified as Restricted.
 
there is one hand guard left. First come, first served so if you want it then get on the blower and call the shop.

As for the original barrel we don't want it, they will be returned to you in the box. If you want to re-install it at a later date that is fine provided you get it verified as restricted.

!?!??!?!?!?!?!?!?!? Wtf
 
We sold the two sets we had in stock within minutes of opening this morning. First come, first served.

Joe has agreed to make another small run of the barrels and handguards however, they shouldn't take long. If you would like to secure one we will do a small pre-order for these but you will need to call with a CC for the NON-REFUNDABLE 50% deposit.

By the end of this week we should be able to get started on these and it shouldn't take long to finish them. 2-3 weeks I hope including bluing / anodizing.
 
Back
Top Bottom