My old 2200 finally stopped after 30 years, and I'd like to replace the motor. Anyone else done this? - dan
Lyman 2200 tumbler rebuild
- Thread starter dan belisle
- Start date
Lyman shows parts. But in reality not worth it.
If you really had to. Maybe an electric motor shop.
Out of stock for the motor/base from Lyman. But I did dig up a motor model. Grainger Dayton 5M065 4 screw mount. So I am on the look out for one of those now. As a new version of this tumbler is close to $400 I figure I have some budget to work with. In the meantime I will dig up a cheaper replacement to use for now. - dan
Burton Urnie
Regular
- Location
- Near Woodstock New Brunswick
Do you have an electronic motor repair place nearby?
It may only need brushes and or bearings replaced.
It may only need brushes and or bearings replaced.
I tried to buy a new 2200 motor and it would have almost cost the price of a new tumbler. All in under $200 and I got the new tumbler a week ago. amaz---.ca. I also bought a small cement mixer for $150 at CT to do large pistol brass batches. Lizard litter crushed walnut in big bags.
Thanks. I found a HD replacement from Dayton Grainger. On the way as I write this. - dan
Only new ones I found of similar performanxce were around 390. I'll fix this for roughly a quarter of that. Been a good tumbler so far. - dan
