What are you using to deburr and chamfer?

O

OldRussian

CGN Regular
Rating - 100%
96   0   0
Location
Edmonton AB
Just finished trimming, deburring, and chamfering a batch of brass. I have the power adapter for my trimmer and can chuck my RCBS deburring tool in my drill. I don't have a power option for the chamfer step. I don't want to have to do that again.

What do you all use for powered chamfer and deburring? Looking for a chamfer tool or 2-in-1 chamfer/deburr that I can put in my drill.
 
I have a Giraud Powered Case trimmer. It trims, deburs, and chamfers at the same time. Worth every penny imo. I timed it yesterday when I was trimming some 308 Win Lapua brass, 3 mins 48 sec to trim, chamfer. and debur 100 cases.
 
The Giraud is definitely on my wish list. I think I am going to hold off on any more gucci reloading gear until 2022. Already picked up a Zero Press and FX 120i this year.
 
I'm using an RCBS trimmer, with the three-way cutter. I replaced teh screw for the crank handle handle with a hex socket head screw, and got the right sized bit for my cordless drill.

Pics are at: ht tps://imgur.com/a/L6JXcia
 
Lyman has or had a inside/outside deburring tool item # 7810210 . It is on a 6" handle about 3/4" in diameter.
I unscrewed the head from the handle and adapted it to the shaft on the end of an old sewing machine motor.
The motor has a foot pedal that varies the speed of the motor. If you have a drivers licence, you should have no problem with the learning curve to operate it.
I have since purchased the latest and greatest Lyman case prep machine. I may use the motor in an annealing set up, so I don't have to cut circles around the water filled pan of cases.
 
I use the giraud fraud lookalike.
I use two in fact, one set in 6.5 and the other in 30 cal.
These lookalikes actually use the real giraud boade to top it off!
Xtreme shooting center trimmer
 
Giraud for comp gun case trimming/deburring/chamfering.

Gracey for rattle battle trimming/deburring/chamfering.

Simple set up on both & equivalent to sharpening a pencil w/ an electric pencil sharpener.
 
I use a "3 in1" tool from Forster on my Forster trimmer with a small cordless drill, works like a charm and gives perfect results.
 
I let the hamster take a few more laps on the wheel and came up with this easy solution to my chamfer problem. A little bit of phase tape and a 5/8 socket holds my RCBS tool well.

51165651552_80b75deeef_c.jpg
 
I use Hornady power chamfer / deburr tools chucked into my drill press. Item Item #050172, and Item #050173, screwed into Lock-N-Load® Attachment Adapter Item #399671
Two separate operations, but I like the results and it's quick and easy.
 
You must log in or register to reply here.
Back
Top Bottom