Tavor Super Sabra Trigger Bow

[Mik123]

For the guys and gals that have the Geissele Super Sabra Trigger Bow installed, how much of an improvement did you see in the pre-travel over the stock trigger. I'm ok with the stock trigger pull but I'd like to decrease the pre-travel. Cheers!

 

[richmyster]

The bow is a huge improvement over the stock trigger. The trigger pack essentially lightens the pull on that improvement.

 

[Mik123]

The bow is a huge improvement over the stock trigger. The trigger pack essentially lightens the pull on that improvement.

Thanks, I'm good with that, the pack is quiet a bit pricier and the Tavor isn't a precision rifle, I'm ok with the stock trigger pull.

 

[richmyster]

Yeah the biggest upgrade in my opinion is the bow... especially for the money.

 

[Dagmaar]

Thanks, I'm good with that, the pack is quiet a bit pricier and the Tavor isn't a precision rifle, I'm ok with the stock trigger pull.

Yup , go with the trigger .
I have the stock trigger pack and the lightning bow trigger and it’s a huge improvement over the stock trigger .
Definitely good bang for your buck .

 

[call2arms]

I have used one that had a bow and one that had the upgraded pack. The pack is an easier install but the bow is better value. If only doing one I would do the bow.

 

[Mik123]

Ordered one from Arms East. Thanks Gents.

 

[call2arms]

Ordered one from Arms East. Thanks Gents.

You need a barrel wrench if you don’t have one

 

[jparent]

You need a barrel wrench if you don’t have one

Concur with everyone's assessment and this piece of advice is paramount. Also advise reading the armorer's manual carefully as there are a lot of steps and fiddly bits to get the bow installed. Adjusting the bow can be a bit of trial and error and it requires re-assembly to test it. You can actually take too much slack out that the trigger won't reset.

 

[Mik123]

I think I'll probably have it installed by my gunsmith, I want to make sure that it is done correctly.

 

[JohnnyP636]

I have both the pack and the bow, the bow by far makes a way bigger differnce in the trigger pull

 

[Kaberday]

I think I'll probably have it installed by my gunsmith, I want to make sure that it is done correctly.

It’s not difficult job, I just watched a video when i did mine. It would give u toooub the opportunity to learn more about your rifle. The only thing is it my take a few tries to get now set right, which involves removing the barrel, which not that difficult l.

 

[richmyster]

I wouldn't pay a gun smith to do the bow. It's very very easy. The x95 is a ridiculously easy rifle to FULLY disassemble. Just go onto YouTube. I can have one taken apart in like 5 minutes. I made my barrel wrench with a grinder and an allen key.

Just remember... DO NOT turn the barrel wrench until AFTER the charging handle and rod are removed or you will damage it.

And as stated you will probably need to take it apart and put it back together again a few times as you adjust the trigger to get rid of the slop. If you go too tight on the adjustment screw the trigger won't reset.

 

[dshymanski]

I have the pack as well as the bow.
Night and day.