You already d you don't want "the best"... you just want "ok."
I started out as a kid with a 6mm Remington. Shot an awful lot of deer and black bears with Winchester Super X 100gr power points.
You are kind of looking at two different aspects here. If you want a harder bullet for a “guaranteed” exit for trailing purposes, you are going to end up needing to trail stuff more.
If you use a softer bullet that fragments more but penetrates less you will have less trailing.
A factory issued 243 with a softer constructed bullet that holds together enough to get to vitals but might not exit will destroy more organ tissue and fold stuff up quicker. About the only option you have for best of both worlds there is the Partition.
You are kind of looking at two different aspects here. If you want a harder bullet for a “guaranteed” exit for trailing purposes, you are going to end up needing to trail stuff more.
If you use a softer bullet that fragments more but penetrates less you will have less trailing.
A factory issued 243 with a softer constructed bullet that holds together enough to get to vitals but might not exit will destroy more organ tissue and fold stuff up quicker. About the only option you have for best of both worlds there is the Partition.
When a person looks at the actual price of the bullet compared to everything else involved in a hunt , they aren't overly expensive , especially when they work so well.Ah, the simple, timeless genius of the good ole Partition.
Ah, the simple, timeless genius of the good ole Partition.
When a person looks at the actual price of the bullet compared to everything else involved in a hunt , they aren't overly expensive , especially when they work so well.
This is a completly unbiased opinion from someone who does not use them . I can't buy them in the cartridge I use.
Cat
Not on the poll but ttsx do both of what you’re asking. I have them loaded for my 6mm rem. Shot a bunch of deer with the ttsx, 90 percent dropped right there with chest shots. All had exits, including the big doe quarter towards me.
Before the ttsx any 100 grain plain jane load did the trick. Most died within 50 yards. Accobonds did not do will in my experience and produced alot of bloodshot. Didn’t like all the lead bits from the partitions, must have been the front part of the bullet, since they did exit and weren’t recovered, they also didn’t shoot well in my 6mm.
Accubond deer was shot high but not spined. Exit was spectacular but lost a lot of meat. Partition did exit, it hit leg bone going in and thats where i found bits of lead in the shoulder meat, it did the job, just wasn’t all that great in my gun for grouping.
Ttsx shoot wellin my 6mm, all deer dropped when hit a a few required a short tracking job. Blood trail was adequate from what I remember. They didn’t require much tracking before being found. I have shot deer with the 55gr tsx from my 223. I tracked one chest shot deer 80 yards, that blood trail was in the snow and was spectacular. No idea how the deer made it that far. The other one i shot that day with the 223 made it 30 yards before piling up.
My go too has always been federal trophy copper. Run it in my .243 and ran it in my .270 and its always done the job. That being said I haven't really used anything else as I've had no reason to stop using the trophy coppers.
Barnes should make the list as well. They do the necessary damage needed and shoot accurately out of many calibres.
Barnes should make the list as well. They do the necessary damage needed and shoot accurately out of many calibres.
100 % Agree ! RJ