TheSil3nce
CGN Regular
- Location
- Quebec - FR
Hello to all,
This is a positive review for Alberta Tactical Rifle Supply one piece scope mount review.
Specs: 15 inch high, 34 mm tube, 20 moa cant built in.
I used it to mount a S&B high power 3-27 on a AI AT rifle.
I come from the Spuhr universe, I had a major issue using my MDT LRA electronic level on a QDP-4602. When I would torque down the rings, the mount would warp a bit and screw up my scope leveling.
I did not have that issue with the ATRS scope mount.
The 4 screw per cap design is also somewhat easier to torque down. I did have to fiddle a bit to get the rings properly in place.
By the way, I had to call ATRS; the cross bolts torque is 55 in.lbs and the ring cap screw are 21 in.lbs.
Once the ring caps were fully tighten down i had a clearance from the base of about 0.04 to 0.05mm. It's not much. But I had plenty spuhr mounts that I would end up with zero gap. So i was very happy with that.
ATRS scope mount is canadian made and also it has the spuhr accessories mounting system. For me it was a no-brainer, as I have quite a bit of accessoiries compatible with this system.
I am very happy so far with the mount and I am looking forward to test the setup.
Thanks for reading, best regards
This is a positive review for Alberta Tactical Rifle Supply one piece scope mount review.
Specs: 15 inch high, 34 mm tube, 20 moa cant built in.
I used it to mount a S&B high power 3-27 on a AI AT rifle.
I come from the Spuhr universe, I had a major issue using my MDT LRA electronic level on a QDP-4602. When I would torque down the rings, the mount would warp a bit and screw up my scope leveling.
I did not have that issue with the ATRS scope mount.
The 4 screw per cap design is also somewhat easier to torque down. I did have to fiddle a bit to get the rings properly in place.
By the way, I had to call ATRS; the cross bolts torque is 55 in.lbs and the ring cap screw are 21 in.lbs.
Once the ring caps were fully tighten down i had a clearance from the base of about 0.04 to 0.05mm. It's not much. But I had plenty spuhr mounts that I would end up with zero gap. So i was very happy with that.
ATRS scope mount is canadian made and also it has the spuhr accessories mounting system. For me it was a no-brainer, as I have quite a bit of accessoiries compatible with this system.
I am very happy so far with the mount and I am looking forward to test the setup.
Thanks for reading, best regards
Attachments
Last edited:
The rings made by ATRS are the best I have ever to use.
