CZ 457 LRP Scope,Base,Rings Match up

[GB22lr]

Good Afternoon All !
I am new to this group and seeking some advice.
I have just purchased a new CZ 457 LRP & I live in a fairly remote location so long drive to get to a gun shop.
Hoping that someone here may have similar set up.

First off looking to shoot 600 plus yards & get into PRS

- Ordered MDT 50 MOA Rail
- Ordered Bushnell Match Pro ED 5-30X 56mm Scope

Looking to pick up MDT Elite scope rings,
Can anyone offer which height Medium 1.0" or High 1.25" would work with this combination ?
As Scope and Rail are in the mail I sadly can't do the measurements here at home and hoping to save a bit of time.

Thanks so much for your comments !

 

[Poffels]

I would suggest the 1.25" height
These are Arken 1.26" rings on a 20 moa mdt rail with 56mm bell, leaves about a 1/2" space
The bell will sit a bit lower on your 50 moa rail
1" may work, but will be snug

 

[GB22lr]

I would suggest the 1.25" height
These are Arken 1.26" rings on a 20 moa mdt rail with 56mm bell, leaves about a 1/2" space
The bell will sit a bit lower on your 50 moa rail
1" may work, but will be snug

Thanks for the input !
Nice set up too !

 

[Arminhammer]

MDT 50 moa rail .97 rings

 

[67Hertz]

I would also recommend 1.25 if you can’t mock up. I also have Match pro 5-30 in 1.25 mdt elites and it works very well. Nice build choices! I have B14R but always wanted to try 457 LRP.

Side note. I am not sure your intended goals but 600 yards is not really possible with .22 unless you are shooting a massive target. Even 300-400 is ambitious.