BIG ONE !!!

Cole said:
View attachment 1134110
Click to expand...
Take an oscillating tool with a wide wood blade, jam it straight down the center of the Crack to create a gap large enough for epoxy to be set. Use a thin blade to push a two part epoxy down and fill the gap you created. When full, tighten a C-clamp on the sides until epoxy lifts at the Crack. Leave the epoxy blistered up, it is easy to sand off later. Refinished with Tru-Oil, or stain to match and then Tru-Oil. Stock will be better than new.
 
hoytcanon said:
Take an oscillating tool with a wide wood blade, jam it straight down the center of the Crack to create a gap large enough for epoxy to be set. Use a thin blade to push a two part epoxy down and fill the gap you created. When full, tighten a C-clamp on the sides until epoxy lifts at the Crack. Leave the epoxy blistered up, it is easy to sand off later. Refinished with Tru-Oil, or stain to match and then Tru-Oil. Stock will be better than new.
Click to expand...
Thats some pretty good info! Thanks!
I have a Hogue Over-molded drop in stock coming to replace it, but will deffinately keep the old stock and maybe during the winter i will attempt to fix it then.
I will be bedding the new stock myself, and it will be done properly with an Acra-glass kit that i have.
 
Got the new stock, its being a bit of a pain. Have to get a new trigger as the one thats on the rifle is to big and wont seat into the trigger mortise. Pun intended. Also got a Vortex red dot mounted. I likes it !!1000009516.jpg
 
You must log in or register to reply here.
Back
Top Bottom