TriggerTech Back in Stock for your MRA rifles!
- Thread starter VictoryRidgeCS
- Start date
VictoryRidgeCS
CGN frequent flyer
You can strip it for parts and use those parts to make a Renegade Rifle, and then put the TriggerTech in that. You can pick up a Renegade Receiver Kit here
I've just not used the thing for a while. Even if somehow they re-allow AR15s again, I don't think it's in much working ability anymore.
Thanks anyways.
VictoryRidgeCS
CGN frequent flyer
For a Renegade Build from "donor parts" you would be using the barrel, barrel nut and handguard (no gas system), the butt stock assembly complete, the fire control group, and the pistol grip. Surely those parts are all "working" The gas affected parts are not used so whatever might not have been working on your AR is likely irrelevant.
VictoryRidgeCS
CGN frequent flyer
This is where it gets tricky because you have to do it at home. CFO will NOT give an ATT to transport the rifle for this type of work.
Often if you ask around at your local gun club, someone will have these tools and you might borrow them, and their expertise(?)
You will need a AR15 (or Renegade) Torque Rod (Reaction Rod), and a bench vise, a castle nut wrench, and a barrel-nut wrench appropriate to your specific model (there are many), . Some pin-punches and a mallet/hammer.
If you are local to Barrie give us a call...
