Need some lathe work.

SuperCub

CGN Ultra frequent flyer
Rating - 100%
611   0   1
Location
SJ / NB
I'm looking for someone to do some lathe work on a FLR 30-30 die. I'd like to have the neck reamed to make this die into a body/bump die with no resizing to the neck at all. I use collet dies for that.

Please advise, thanks.
 
I'm looking for someone to do some lathe work on a FLR 30-30 die. I'd like to have the neck reamed to make this die into a body/bump die with no resizing to the neck at all. I use collet dies for that.

Please advise, thanks.
Not sure that you would need a lathe? The die is not going to touch the brass at that point - so does not have to be concentric or even finished that well - maybe a drill of suitable size - like in a drill press?
 
Easy to do on a lathe, your thoughts are correct. Few seconds on a lathe to do. Would not recommend a drill press.

Would also do it for you if you were anywhere close to me.

HSS can run into the 70-72 HRC range, but will still not the best option when cutting over 45-50HRC. It can be done, but there are better options.
 
Reloading dies are hardened steel running in the range of RC 55-60+. Whoever does the job will likely need to use carbide. I believe HSS runs about RC 62-64, so very little hardness differential.
Drilling out a sizing die would definitely destroy the drill bit. Unless you happen to have a carbide drill bit.

The problem with boring a hole that small is having a boring bar that small. Not everyone does.
 
Rotate the die in a chuck and use a small wheel on a dremel in and out of the neck is an option as oversize is fine... not a critical dimension.

OR... heat the die to anneal it and drill it out. The die doesn't really have to be hard if you use clean brass and lube when using it.
 
Back
Top Bottom