Neck tension on 45 70 with cast bullets?

I use a NOE expander plug in a Lee Expander die ( factory taper expander ). The NOE plugs are stepped to expand the case with slight tension with an oversized step at the top that allows the bullet to sit just into the case for straight seating. Zero bulged brass and perfect feeding. Don’t remember the cost but don’t remember it being unreasonable. Ordered multiple calibers and they work great for straight wall or bottle neck cartridges.
 

Attachments

  • IMG_5890.jpeg
    IMG_5890.jpeg
    48.4 KB · Views: 4
  • IMG_5891.jpeg
    IMG_5891.jpeg
    52.7 KB · Views: 4
  • Like
Reactions: CRF
also wonder if this bulge is only seen with new brass, like I always get with fresh brass before fire forming, its going to show on one side just by nature of the brass, nothing to do with the die. Starline brass is forgiving this way, I partial resize just to get some neck back and leave the body alone. enough to hold the bullet and a crimp, brass lasts forever the less it is worked.
Kevin32, Not sure why you feel the need to full length resize ?

My trapdoors latch isn't always fully closing without applying forcd. I have to do a little more research tho because it seems like it's because the bullets aren't seating straight.

I'm still considering more the Lee expanders from track of the wolf as my .461 bullets will still be squeezed quite a bit down in .4565 rcbs dies.
 
Last edited:
it will be interesting to see what your chamber cast proves out
a proper look with a bore scope will help knowing the condition and amount of fouling in place too
It's pretty clean barrel. .460 is from measuring a bullet I've pushed into the muzzle so using a .461 bullet. Its a bastard trapdoor with a Marlin microgroove barrel - great shooter tho.

The noe plugs are 8usd each and 50$ shipping. Debating between them and track of the wolf now.
 
Back
Top Bottom