7mm Rem Mag - all bark, no bite

As mentioned it could be an ammo issue, or a rifle issue.

If the rifle performs as expected with other ammo and/or handloads, then obviously an ammo issue, with that lot #.
I have typically gotten close to factory specs with Fusion ammo in other cartridges and 22-24" barrels.
If you haven't tried other ammo, and then do, and still get slow velocities, then it is likely a rifle issue. Might just be a slow barrel.

Have seen this in the past. E.g., A friend's new M70 Featherweight in 280 Rem in the early 2000s was typically 200-400 fps slow with various factory ammo and handloads until he had 400 rounds down the pipe, then it picked up to where it should have been. Accuracy was good right from the start, so he just accepted the velocity, and kept shooting it, Was much happier when it finally came around.
 
While I say this not from 1st hand personal experience but it seems to to me that there have long been quiet rumours from some that the 7mag can be surprisingly slow over a chrony. I hold that the problem is likely factory ammo.
I’ve run lots of SLOW 7 RMag ammo past my Lab Radar and my Garmin ! I’ve never seen any that will do the advertised FPS
Really pisses guys off at the range when my 30-06 ( Handloads) blow past there Mighty 7 RM s 🤣

Now with GOOD HANDLOADS the 7 RM is a Great Cartridge 👍 but the 7 PRC is a bit Better 😀
 
Back when Christ was a Lance Corporal, I invited a few fellows to the range with their 24” barrelled 7mm REM Mags, I put up the factory ammo, and we ran those rifles over the chrony. It was right after Christmas and it was around -8 on that day.

Federal blue box 150’s advertised MV of 3110 fps
Winchester SuperX 175’s advertised MV of 2860 fps.

We had a Tikka 695
Sako 75
Sako AV
A REM 700
And. REM 700 Sendaro with a 26” bbl

Here’s how the loads Chronied:

Tikka 695;
150 avg velocity 2925 fps
175 avg velocity 2708 fps

Sako 75;
150 avg velocity 2945 fps
175 avg velocity 2717 fps

Sako AV;
150 avg velocity 2936 fps
175 avg velocity 2723 fps

REM 700;
150 avg velocity 2974 fps
175 avg velocity 2699 fps

Sendaro 26”;
150 avg velocity 3013 fps
175 avg velocity 2754 fps.

Take it for what it’s worth but in one of the older Speer reloading manuals they talked precisely about the 7mm REM Mag and its inability to live up to factory billing and hence they used a test barrel instead of a factory rifle in the production of their load data.

Something is a bit off with the good old 7RM……. And it ain’t all that and a bag of Cheetos, being it’s known for pressure spikes and plagued with mediocre velocities when the pressure spikes are respected.
 
Last edited:
Behold the bag of Cheetos.

cbWPr1K.jpeg
 
If one is looking for top end performance from any kind of purchased ammunition… then they should probably be looking somewhere else.
Not really sure why this is news… especially with a 7 RM.

R.
 
Pretty happy I can get 7x57 150 loads up into the mid to high 2800fps range then. Obviously hand loads.

Imagine my suprise when I worked a couple up into the 2940 range with 150s in a 22inch rem700 mountain. Didnt keep them there. Don't imagine primer pockets would stay tight for long. Spicey.
 
I have a 7x57 that will best that.
Do you handload? If so, get yourself a couple of pounds of Ramshot Grand, visit the Hodgdon website for data, and watch the 7RM transform into what it was meant to be.
N560 will push 175gr at a touch under 3000fps
So will r26 if it can be found but I haven’t used grand yet
 
Take it for what it’s worth but in one of the older Speer reloading manuals they talked precisely about the 7mm REM Mag and its inability to live up to factory billing and hence they used a test barrel instead of a factory rifle in the production of their load data.

Can confirm, my Speer #12, 3rd printing in 1995 has that.

1000035684.jpg
 
Back
Top Bottom