Sig Carbine

heavenIsAlie said:
didnt swiss arms impoting get taken over by someone else? or was that the kimbers
Click to expand...

The "official" importer of Swiss Arms is R Nicholls. However, Swiss Arms is honouring all of our back orders, so, given their delivery, we will have rifles trickling in for quite some time.

BTW, we also still import Kimbers direct as well.

JR
 
So what kind of rail is that? The B+T seems to have rectangular vent holes. And how did you get the KAC panels to work? Do they lock in place?
 
The railed forend is SwissArms as mentioned & the Knight's covers do snap in with a bit of tweeking.
The top rail is Kyle Precision - a well made rail -Good job Bryce;)
I'm not sure having the two lining up really matters as the fore rail isn't floated nor secure...however, if you are talking making a monolithic rail/foreend that would be a floated handguard, I would agree it would sell very well. Someone should get on that.

The fore rail was too much, but I've gotten a promotion at work and was feeling cheeky:D
 
If then enjoyment I'm getting from those pics is just a fraction of the enjoyment you're getting from fondling it, then you must really really be getting some enjoyment.

Thanks for the pics. :) It's gorgeous. I'm green with envy!
 
beltfed said:
if you are talking making a monolithic rail/foreend that would be a floated handguard, I would agree it would sell very well. Someone should get on that.

The fore rail was too much, but I've gotten a promotion at work and was feeling cheeky:D
Click to expand...

Yes Yes YES!!, Step the f**k up Bryce we are waiting for you to make your mark and this for sure would be it!!!:slap::wave::p:D
 
juliet lima said:
I wish SOMEONE (Bryce) would build a lowlowlow rail for the sig that would line up with the fore end quad and allow a co witness with optics.

jl
Click to expand...
The Swiss Arms iron sites are really low, I don't think you've be able to make a rail low enough to co-witness an Aimpoint or Eotech. Maybe one of those small Doctor Optic sites.

Also, due to the screw in the back, you need material. So the rail would have to be bigger at the screw part, then get as low as possible. If you rally wanted to, you'd probably have to get a low low rail welded on.

We've actually been hearing more calls for a higher rial.
 
Armedsask said:
The Swiss Arms iron sites are really low, I don't think you've be able to make a rail low enough to co-witness an Aimpoint or Eotech. Maybe one of those small Doctor Optic sites.

Also, due to the screw in the back, you need material. So the rail would have to be bigger at the screw part, then get as low as possible. If you rally wanted to, you'd probably have to get a low low rail welded on.

We've actually been hearing more calls for a higher rial.
Click to expand...

Ah, you're here. Care to tell us why the Picatinny adapter is roughly the same price as the B+T?
 
koalorka said:
Ah, you're here. Care to tell us why the Picatinny adapter is roughly the same price as the B+T?
Click to expand...


Forget about the price, what they need to make is something better and by better I mean a longer top rail.

Make the top rail a couple inches longer extending over the top of the handguard and I would buy two, this copy of the B&T offers nothing better.
 
If I were Bryce I would make it a bit taller, run it out over the handguard and mill a sight groove down the center of it if it needed it.
 
You must log in or register to reply here.
Back
Top Bottom