You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
M14 custom barrel?
- Thread starter jassoplau
- Start date
Can you or is it possible to have the M14 re-barreled for say a thicker barrel and if so who can do this?
Yes, but no rethreading needed.
Krieger barrel makes medium DMR SS barrels and heavy ss barrels
Price between 500to600 plus install.
Barrel torque shoulder must be machined and chamber cut as the come with no torque shoulder relief and are short chambered.
Torque shoulder must be cut according to desired final draw, with the individual receiver it is to be installed on.
Obtunded here on CGN was a krieger dealer but as he never answers his email and his PM function is off.
I suppose we need another enterprising importer to step up and get these barrels.
I have full equipment , guages and tooling for this service
So it can be done thats good. Now if you can do the install who can order/get the krieger barrel? Also is the medium barrel thicker than the barrel that comes with the Norinco m14/m305?
Yes, but no rethreading needed.
Krieger barrel makes medium DMR SS barrels and heavy ss barrels
Price between 500to600 plus install.
Barrel torque shoulder must be machined and chamber cut as the come with no torque shoulder relief and are short chambered.
Torque shoulder must be cut according to desired final draw, with the individual receiver it is to be installed on.
Obtunded here on CGN was a krieger dealer but as he never answers his email and his PM function is off.
I suppose we need another enterprising importer to step up and get these barrels.
I have full equipment , guages and tooling for this service
So it can be done thats good. Now if you can do the install who can order/get the krieger barrel? Also is the medium barrel thicker than the barrel that comes with the Norinco m14/m305?
Post an add in dealer forum,
Medium barrel goes same diameter to oprod guide then thinner forward. Gas assembly and flash hider mount the same as on your norc but you will need M1A or usgi gas lock and castlenut
