- Location
- Prairie drifter
Yup. Just to the outdoor ones I hate shooting inside.
1911's Pics Thread
- Thread starter Nats
- Start date
Yup. Just to the outdoor ones I hate shooting inside.
finally I'm done with my project Nork 1911A1C--- new pics ---
Wolf, what kind of barrel and barrel bushing is that? Looks great.
finally I'm done with my project Nork 1911A1C--- new pics ---
I say you aren't finished quite just yet.... you need to add stainless hex grip screws.... then you are finished....
Nice job so far, though....
NAA.
- Location
- Lower Mainland BC
Dave the barrel is original Norinco
bushing is a thick flange 0.125 Fusion Commander no fitting required !
bushing is a thick flange 0.125 Fusion Commander no fitting required !
- Location
- Lower Mainland BC
NAA yeah you're right....Bob from Fusion didn't put in the mail my SS torx stainless grip screws ...hope next week will be here.
you know that Norcs use mm bushing thread and I cannot use the regular 1911
you know that Norcs use mm bushing thread and I cannot use the regular 1911
Last edited:
IIRC it's the thread on the bushings that goes into the frame that is different than standard mil-spec 1911 grip screw bushings BUT the bushings themselves will accept standard thread grip screws - slotted or hex or torx.......
Still, that's one beautiful commander 1911, though..........
NAA.
heavenIsAlie
CGN Ultra frequent flyer
- Location
- Abbotsford
to bad im selling it to fund another gun
so good looking
The latest addition to the family - and fast becoming a favorite. For such a loose gun it certainly doesn't hold me back, in fact, I still have a lot of growing to do. Though I have a couple pretty faces, this one is on it's way to the work horse placement. Bob the hammer, new MSH and I'm happy. Next I think a full Norc project is in order. Sorry about the pics.
My Argentine Colt and Ithaca jalopy after an afternoon of cleanup. Ready to send off to get refinished. The Ithaca frame will be fixed up, and will have to wear a Remington Rand slide for now, until a suitable replacement comes along.
Bittermansbro
CGN frequent flyer
- Location
- Calgary, AB
Ooooh, I am sure looking forward to seeing how these look when they come back!
Who do you send your stuff to, deadman?
Pocketfisherman put me in touch with a buddy of his. I think you may have seen his work (Singer repro). I've never refinished a pistol before, for now I'll leave it to the pros. I should have left more to him, this weekend I found out how not to remove front sights 
.
.
Guys,
Looking for advice on the current Canadian street value of the US&S. The last one I sold went for $3500.00 and it was not as nice as the one below. Most US auctions seem to have them from around 4K-6K
Looking for advice on the current Canadian street value of the US&S. The last one I sold went for $3500.00 and it was not as nice as the one below. Most US auctions seem to have them from around 4K-6K
Shazaam!
Sorry for the crappy pic...
