Finally got my CZ where I want it

[mikerock]

CZH-2003 with original CZ wood (c/o Curtton,) smith mounted AK rail and Russian red dot. This has been a two year long project to get the right parts, and a competent gunsmith to do the fitting and mounting.

 

[308smk]

hows the cheekweld on that rig?

Looks cool

 

[Curtton]

CZH-2003 with original CZ wood (c/o Curtton,) smith mounted AK rail and Russian red dot. This has been a two year long project to get the right parts, and a competent gunsmith to do the fitting and mounting.

looking good mike. how did the smith attached the mount, do you have pic of the inside ?

 

[Until the Angels Fall]

Looks good man

 

[DrakeriderCa]

hahaha this gun is ugly and so are you




I'm holding hands with my cat

 

[lone-wolf]

looking good mike. how did the smith attached the mount, do you have pic of the inside ?

x2, I'd like to see that too.

 

[GrensVegter]

I drilled and tapped the receiver on a mill to ensure the mount being true with the barrel/receiver. The rear screw is locknuted with a nut to ensure the mounting screws don't rattle loose the front screw is locktited into the forward block of the 2003's which is different to the 858's. However once we have determined the rifle Shoots to point of aim and no further tweaking is needed I would prefer to replace the locknut with a lock plate .

 

[mikerock]

I drilled and tapped the receiver on a mill to ensure the mount being true with the barrel/receiver. The rear screw is locknuted with a nut to ensure the mounting screws don't rattle loose the front screw is locktited into the forward block of the 2003's which is different to the 858's. However once we have determined the rifle Shoots to point of aim and no further tweaking is needed I would prefer to replace the locknut with a lock plate .

If you're OK with it I'll post pictures.