When I picked up my CSA in October, I never really intended to mod it all that much. Then in January, I called up wolverine and ordered the receiver scope mount intended for these rifles, then came the fab goodness. Hopefully the pics turn out...
The fab stuff was a bit of a pain to install. Upper hand guard, no issue. Lower hand guard required some filing on the rear inside edge to get it to squeeze in. The one pic shows the slight gap between receiver and hand guard. The skeleton stock was a major PITA to remove. Held in by a 6mm allen bolt from the inside of the receiver and torqued to ungodly specs, it only came out after breaking a 1/4" drive ratchet and eventually shearing the bolt itself. The only other minor issue was with the new pistol grip. The long, hollow battery/whatever compartment meant the factory bolt was much too long. easy fix was to just add washers until the bolt no longer protruded into the receiver (bye bye battery compartment) Once finished, there was no play whatsoever with hand guards, butt stock or pistol grip.
The receiver mount from wolverine seems to be a solid unit, and once tightened down, feels very solid and places the rail over the bore nicely (there may be an offset of maybe a mm or two, its hard to tell, and I couldn't get a good pic). For now, I slapped on an old burris 3-9 I had in some millet rings. Hopefully hitting a range this weekend to see how she shoots!
edit: there does seem to be an issue with eye relief. Due to the short rail and location of the turrets on this burris, even with stock fully extended I am having to lean my head back to get a good sight picture...keeping that in mind when I eventually search for a new optic
The fab stuff was a bit of a pain to install. Upper hand guard, no issue. Lower hand guard required some filing on the rear inside edge to get it to squeeze in. The one pic shows the slight gap between receiver and hand guard. The skeleton stock was a major PITA to remove. Held in by a 6mm allen bolt from the inside of the receiver and torqued to ungodly specs, it only came out after breaking a 1/4" drive ratchet and eventually shearing the bolt itself. The only other minor issue was with the new pistol grip. The long, hollow battery/whatever compartment meant the factory bolt was much too long. easy fix was to just add washers until the bolt no longer protruded into the receiver (bye bye battery compartment) Once finished, there was no play whatsoever with hand guards, butt stock or pistol grip.
The receiver mount from wolverine seems to be a solid unit, and once tightened down, feels very solid and places the rail over the bore nicely (there may be an offset of maybe a mm or two, its hard to tell, and I couldn't get a good pic). For now, I slapped on an old burris 3-9 I had in some millet rings. Hopefully hitting a range this weekend to see how she shoots!
edit: there does seem to be an issue with eye relief. Due to the short rail and location of the turrets on this burris, even with stock fully extended I am having to lean my head back to get a good sight picture...keeping that in mind when I eventually search for a new optic



















































