DA Grizzly Not Feeding From Tube

[ridgearms]

Hi Guys,

I picked up a grizzly receiver which i built a tactical set up around. I took it out for the first time yesterday after I had duracoated it last month. The rounds would not feed from the tube. I think it is the arms on either side of the mag. They do not seem to depress at all when cycling the action so as to let the round out. If I half #### the action and depress the springs with my nails the round comes flying out. I read another thread that said that it might be those springy arms that need replacing. Here is a pic in case anyone can see something out of whack.

 

[B]

Hi, I had the same thing happened to me with a 12.5" DA Grizzly. Some douche sold me the gun knowing it had problems. Solution was new shell latches...

 

[P12]

I had the same problem too, but mine were also falling out, which was kinda good because I could take them out, reshape and polish the tip of it with some very fine sand paper, 1000 grit I think. Than I restaked it and it works fine now.

 

[B]

I had the same problem too, but mine were also falling out, which was kinda good because I could take them out, reshape and polish the tip of it with some very fine sand paper, 1000 grit I think. Than I restaked it and it works fine now.

The left latch on an HP-9 I owned fell right out the fist time I disassembled. I have had pretty poor luck with Chinese shotguns.