RONI Glock Carbine conversion kits - Good news!
- Thread starter Wakeness
- Start date
Weird! I just measured my tan one and it's 4 and 3/16th of an inch?? WTF?? It fits my G17 like a glove though, sh1t QC here or what's going on
We got the answer... The muzzlebrake "lips" don't go far enough over the Glock's slide...
Here's BEFORE closing the muzzle cap:
Here's AFTER closing the muzzle cap:
As you can see on the picture above, the muzzlebrake is resting on the front face of the slide.
It don't go over the slide like the original roni's muzzlebrake which cover the frontal area for the muzzle blast!
Here's the original Roni and where the muzzlebrake sits on the slide:
Last edited:
The internal muzzle brake is adjustable for position so it is possible your black one was just not assembled properly.
I had a look at the real Roni at SHOT and the tan ones we are getting are not the real thing. Still happy with my fake Roni as it cost 1/4 what a real one does.
I had a look at the real Roni at SHOT and the tan ones we are getting are not the real thing. Still happy with my fake Roni as it cost 1/4 what a real one does.
I've tried it and the other hole is for the installation of a Glock 19 (Small Frame)...
Arloashean
CGN Regular
- Location
- People's Republic of Toronto
The barrel shroud length seems a plausible explanation (who says size doesn't matter).
I noted one of the posters had found a replacement shroud for his G34. Is there a replacement available for the g17 or other regular-length Glocks?
I noted one of the posters had found a replacement shroud for his G34. Is there a replacement available for the g17 or other regular-length Glocks?
You're thinking about repiercing an other hole for the under screw and treading it so it fits over the slide?
It's a single metal tube with muzzle slots at the top front.
Actually the vents are on the sides on my copy and the original one I bought has one vent on top. , I have the front half of one you could have if you need it ....as I cut the one I received down to test fit my 34 in my kit.
I threw the back half with the muzzle shroud away and I assume that this is the part you need...
The front half still uses the original mounting screw with the kit.This is the part you can have.
I threw the back half with the muzzle shroud away and I assume that this is the part you need...
The front half still uses the original mounting screw with the kit.This is the part you can have.
Yes. In fact I will prob cut off the front part as well.
You're thinking about repiercing an other hole for the under screw and treading it so it fits over the slide?
No. I am thinking of building a can that mounts to the chassis not the gun itself.
how does the slide pull back? i see the little adapter that comes with the kit but how does it work?
also i have seen two other kits from different companys and they have the addapters for a KSG or TM gun? does one of thoughs fit the real glock? like if i buy a kit that is for a TM glock will the slide pull back thing work on my real g17?
also i have seen two other kits from different companys and they have the addapters for a KSG or TM gun? does one of thoughs fit the real glock? like if i buy a kit that is for a TM glock will the slide pull back thing work on my real g17?
Moparlover
CGN frequent flyer
or for someone thinking they're buying a real Roni kit and receiving airsoft garbage.
