JR Carbine

[fleabaggins]

Hi there,
does anyone know the exact method for removing the pin from the JR Carbine buttstock so it collapses?
Thanks

 

[mwentrot]

I just drilled mine out, I know others have used a type of bit to drill in a bit and then pull the bit with the pin attached.

 

[Rugerman]

I just drilled mine out, I know others have used a type of bit to drill in a bit and then pull the bit with the pin attached.

Either way that mwentrot describes works well. I don't recommend you do it the way JR company recommends. It's too complicated and too much of a chance to do some damage to your stock. My roll pin was only half way in when I bought it so setting a screw in it and pulling it out with vise grips was very simple.

 

[SpongyMonster]

I used a tapping screw ... drove it in until it engaged a few threads then used a pair of vice grips on the head of the screw to pull the screw and spring pin out.

 

[G37]

I used an allen key that was a tight fit... then rotated back and forth in addition to pulling outward. Not the most elegant method, but it worked (took a few minutes).

 

[newless]

Drill, drill, drill. I broke a drill bit on mine.

 

[K0na_stinky]

I shot mine about 300 times... and the pin was loose enough to fall out on its own.

 

[archer2u]

I shot mine about 300 times... and the pin was loose enough to fall out on its own.

x2 mine fell out after 250 rds

 

[Zeroed-In]

I too broke a small drill bit in my attempt to drill out the pin that stops the movement of the stock from collasping, yet I was in far enough to knock it out with a appropriately sized punch, which worked but made the hole a little unprofessional looking so then all I did was drill out the hole slightly larger for a clean look, now it works and looks good

 

[Filipino Redneck]

Mine was pushed in as I bought mine used, so I couldnt pull it out. I drilled another hole from the opposite side and punched it out.

 

[B]

I just used a punch... It took me about 15 seconds start to finish.

 

[WRH]

I used a drill bit that was small enough to slide through the center on the pin, this creating a pilot hole in the plastic stock. I then used a bit the size of the pin to drill from the other side. Then I pushed the pin out with a punch.

 

[agilent_one]

Punch

 

[ktmpilot]

I grabbed with side cutters and popped it out. 2 second job

 

[#1bcshooter]

I just got rid of the whole thing & put on a real mans stock