1. Make sure gun is unloaded.
2. push the take down pin to the left
3. using foward force push and lift the receiver cover
4. Pull the bolt all the way to the rear.
5. With the bolt at the at the rear remove the two cocking lugs
6. Once both cocking lugs are removed pull out the bolt
7. To remove the upper reciver cover insert a small punch and push the locking spring to the take down pin in and turn clockwise ***WARNING***
DO NOT PULL OUT THE TAKE DOWN PIN ALL THE WAY OUT OR THE OR THE LOCKING SPRING WILL FLY INTO OUTTER SPACE!!!
8. Release the hammer by pressing on the trigger reset lever
9. Maintain pressure on the hammer as you press on the trigger and ride the hammer home so it does to slam.
****THIS IS THE COMPLESTE FIELD STRIP THE NEXT STEPS ARE MORE DIFFICULT PROCEDE AT YOUR OWN RISK*****
10. Remove the middle lower receiver pin
11. Pushing down simultaneously on both pins remove the hammer pin locking plate *** WARNING BOTH PLATE PINS ARE UNDER SPRING PRESSURE AND WILL FLY LIKE A ICBM AS SOON AS THE LOCKING PLATE IS REMOVED***
12. Remove the hammer pin
13. Remove the hammer and the hammer spring by pushing the hammer back and up.
14. Rotate the selector lever counter clockwise until it lines up with the removal slot
15. Pushing down on the hammer catch sear remove the selector lever by pulling it to the left of the gun if the barrel is facing away from you
16. To remove the trigger mec. pull the trigger towards the barrel then use a upward and backwards motion
17. push down on both recoil springs and remove the recoil spriong retainer
18. Remove the recoil springs and recoil springs guide rods
19. ***WARNING NEXT STEP IS REMOVING THE FIRING PIN THAT IS UNDER PRESSURE MAKE SURE TO KEEP PRESSURE ON IT AT THE BACK OF THE BOLT.
20. Remove the firing pin retention pin farthest from the bolt face, remove the 3 part firing pin striker,firing pin and spring
21. Remove the extractor retaining pin closest to the bolt face, this one is also under spring pressure but not much.
Hope this helps all of the new proud owners with m84 and CZ-91 Skorpions
Last edited:
