I don't have a case tumbler and don't plan on getting one but I have some reloads that are looking a bit shabby. I have a can of "Flitz" it looks like a fibrous mat. You just tear off what you need. Does anyone use this on their brass ? I suspect it it would be OK. What do you guy's think ???
Flitz Brass polish
- Thread starter got to go
- Start date
Wash the brass in a mix of a liter of water, a table spoon of liquid laundry detergent and with two cups of cheap white vinegar. It'll quickly remove all but the worst possible tarnish from the brass and leave it looking like you hand buffed ever casing. Just dump it in and agitate a few times over the course of a 10 minute soak and you're done.
Using this same mixture in an ultrasonic cleaner on brass that has been de-capped leaves the inside looking like it was new again.
In each case rinse well with a first rinse bucket and then transfer to a second rinse to remove the soap and vinegar from inside and out.
Using this same mixture in an ultrasonic cleaner on brass that has been de-capped leaves the inside looking like it was new again.
In each case rinse well with a first rinse bucket and then transfer to a second rinse to remove the soap and vinegar from inside and out.
It is "Nevr Dull" I was thinking it was Flitz.
I forgot to mention that the brass is loaded. I was wondering if the "Nevr Dull" might have some type of penetrating oil in it that might cause problems with the primers.
