PurpleCrow
CGN Regular
- Location
- The Chilly North
http://www.thefirearmblog.com/blog/2013/03/05/iwi-developing-a-7-62x51mm-tavor-x95-rifle/
Depends what you mean by parts. A 7.62x51 rifle is a lot bigger so it will have a lot different parts.Bring it on! Hope you can swap parts.
I would like a 6.8 or 6.5 tavor before a 7.62x51 because I know the big daddy will weigh at least 2 pounds more than the current set up
I would happily. 900 grams would do me a whole lotta good.yeah, but on the upside, you can cancel your gym membership![]()
Well, no... *take* one. It will give you an excuse to muscle upyeah, but on the upside, you can cancel your gym membership![]()
Not exactly sure where you read that... it clearly says 7.62 like the bullets used in the MAG (FN MAG)Actually the article suggests different caliber using the same magazine configuration, so they are more than likely looking at something similar to a 300blk not a 7.62x51.
Not exactly sure where you read that... it clearly says 7.62 like the bullets used in the MAG (FN MAG)
Yeah... The IDF barely uses pistols because 9mm are more expensive than 5.56 in Israel. There's no way we would switch to an even more expensive round for widespread use. It's all about what is widely used and readily available for not a lot of money.This lol there was a large debate when I posted this article a month or so back about it being chambered in .300 Blogout. Not sure why it seems so hard to comprehend that it is going to be chambered in 7.62 NATO. ..
Yeah... The IDF barely uses pistols because 9mm are more expensive than 5.56 in Israel. There's no way we would switch to an even more expensive round for widespread use. It's all about what is widely used and readily available for not a lot of money.



























