KSG Barrel nut tool...if your looking heres a good spot to start

Outcast

Outcast

CGN Ultra frequent flyer
Rating - 100%
287   0   1
Location
One stop from 100 acres with a house in the middle
Not sure if this was posted before, but if you have been looking for the KSG Barrel nut tool these guys make them. Shipped from St. Louis was $47.00
On a sunday afternoon I had all my questions answered and the product paid for and shipped. Google SMT Tactical...great guys to deal with.
 
Barthom said:
Crazy though, hey? Quite the expense for a 20 second once in a lifetime use.
Click to expand...

Ya no kidding... But since its Christmas in June. I'd hate not to spend a couple bucks and fudge something up.

I was thinking I'd charge $10 a pop for locals to use it, cheaper for them and I'll make money.... Kidding.

Well in a week or two if there are locals who need it just PM me and we can meet up and test her out on your KSG.
 
KSG Enforcer arrived today, I need to decide which tool to get.

For those who have installed brake on their KSG, did you have to use heat or just the tool alone?
 
Parts arrived today, took 60 seconds to remove barrel nut and install enforcer.

ksgh.jpg


ksgg.jpg
 
Outcast said:
Did you have to heat the crap out of it? I tried removing my barrel nut yesterday and can't friggin budge it.
Click to expand...

Nope, no heat.

did you try and remove with the tool or other method?

I put ksg between my knees and tool on barrel nut, then with hand on each side of the rod and twisted. I expected it would be lot harder.
 
f55 said:
Nope, no heat.

did you try and remove with the tool or other method?

I put ksg between my knees and tool on barrel nut, then with hand on each side of the rod and twisted. I expected it would be lot harder.
Click to expand...

I have the same tool as you , heated it up with a hair dryer for about 4-5 min, pretty hot. Had the KSG in a vice and couldn't move that mother if my life depended on it. Likely going to have to go to my local smith and see if he has a trick. Thanks.
 
I have the SMT Tactical choke tube adapter for my KSG, I also have the tool they make to remove the factory barrel nut... I did use a heat gun with a buddy to sweat the barrel nut 'loose', no problems removing it after that.

BUT, my question is, are you guys shooting slugs out of your KSG's with the brakes installed? The guys at SMT Tactical specifically note NOT to shoot slugs through the adapter & that's the reason I took it off & will only use it for hunting & buckshot/birdshot...

I guess the slugs/buckshot don't touch the brake on the way out?

Cheers
Jay
 
You must log in or register to reply here.
Back
Top Bottom