T97 Flash Hider Replacement

[touch157]

Has anyone taken the flash hider off yet? Looks pinned like the Robarms XCR. Is it threaded 1/2x28?

 

[223762]

they are pinned.

 

[touch157]

Yes read they're pinned. I dremeled the fh off my XCR and figured to do the same. Just wondered if anyone has tried yet and what the thread size is. Doesn't look like anyone has tried yet.

 

[fenceline]

Thought about driving the pin out and seeing what the deal is. Just haven't done it yet. Figured someone else would have by now haha.

 

[Crazyest Canuck]

Has anyone taken the flash hider off yet? Looks pinned like the Robarms XCR. Is it threaded 1/2x28?

Yep and once you have it out you have to heat up the muzzle device to slide it off. Then go to cncwarrior and purchase the tap set and thread the end of it and now you will be good to go

 

[BigDerp]

Yep and once you have it out you have to heat up the muzzle device to slide it off. Then go to cncwarrior and purchase the tap set and thread the end of it and now you will be good to go

Has someone already confirmed the barrel isn't threaded?

 

[8 ball]

Post #4 on the T97 sticky thread above.

 

[bfiles]

Yep and once you have it out you have to heat up the muzzle device to slide it off. Then go to cncwarrior and purchase the tap set and thread the end of it and now you will be good to go

Does cncwarrior even ship to Canada???
I ve tried before but it says only us address'

 

[BigDerp]

Post #4 on the T97 sticky thread above.

Thanks, didn't realize that was in the sticky.

 

[Hitzy]

Is the barrel thick enough to thread it 1/2x28?