Remington model 25 rebore?

[Rotaxpower]

I got my self a nice little Remington model 25 in 25-20 with a barrel thats completely pitted through out the bore and needs to be re-barreled, I got thinking that instead of getting a new barrel installed on it I would get it rebored out to a 32-20. Anybody know who would be able to do the work on it and approximate cost on doing it? I have to do a little more research on it before I get it done too, this one is a little different than the other model 25's I have. Right above the serial number it is stamped AA. Not sure what that means, any one have any ideas on that? Thanks again.

 

[Blastattack]

Ron Smith can re-bore it for you.

 

[Rotaxpower]

Thanks! Do you have his phone number?

 

[mbogo3]

403-631-2405

 

[Andy]

That's a rare gun - it will be nice to see it shooting again. I have one in 32-20 and it's sweet.

 

[notsorichguy]

There's also M&S Stocking in Leader SK. They do re-boring...... I don't have the contact info handy, but Google should work.

 

[Rotaxpower]

That's a rare gun - it will be nice to see it shooting again. I have one in 32-20 and it's sweet.

This is my third one , I got two in 25-20 (on with a bad bore) and one in 32-20 as well! I love these little pumps. I also need a few other parts to get this old girl shooting again, I need a firing pin as well. I better find one of them before I get it sent out to rebore it.

One more question, if I get it rebored to 32-20 do I need to get a finish reamer and have the headspace set? The 32-20 should headspace the same as the 25-20 correct? Thanks again!