Review of the Y/MA 95-002 scope for the T97NSR rifle

FeralChild

Member
Rating - 100%
18   0   0
Location
QC
Here are the specifications and first impressions of the Y/MA 95-002 scope.
The Y/MA 95-002 scope is designed for the Chinese 95-1 (5.8mm) family of rifles, as well as fitting the earlier 95 and the 97 (5.56mm) series rifles.
Weight: 250 g
Length: 210 mm
Height: 60 mm​
Designed to fit the distinctive Chinese optics rail, the scope locks in place with a quick-release lever, allowing it to be removed so the rifle can be disassembled for cleaning. The scope's centreline is 37 mm above the mounting rail, making it lower than if using a Picatinny adapter with a conventional scope.
Its magnification is ≈3X, fixed focus, with 15 mm ocular and 16.7 mm objective coated lenses.
The reticule has yellow-green LED lighting for use in low light situations. The manufacturer's data sheet indicates that it uses a 3 Volt CR1/3N lithium battery, whereas it actually needs two. A better solution is to use a single 6 Volt battery, A544 (alkaline) or L544 (lithium). Both the original and the recommended batteries are slightly smaller in diameter than the battery compartment. Wrapping the battery with a few layers of tape helps hold it in its correct position. The negative battery terminal goes inward against the spring.
The reticule is of the range-estimating type using a Chinese system, similar in principle but different from the more familiar MilDot reticules. Both the elevation and windage adjustment dials have 30 clicks per turn. Each click gives 0.25 "mil" (milliradian) or 2.5 cm at 100 metres distance. The scope is designed to be sighted-in at 100 metres, and when used with the Chinese 5.8x42mm cartridge, it will also be on target at 200 metres. Results could be different with various 5.56x45mm loads. Here is a translation of the elevation and windage markings:
Turret covers: 校枪打开 open for sight-in
Dial face: 弹向point of impact
Top (elevation) adjustment: 上 raise CCW / 下 lower CW
Left side (windage) adjustment: 右 right CCW / 左 left CW​
It comes with a leather carrying case, and is fitted with a waterproof front lens cover. A rubber eyepiece cuts out ambient light as well as maintaining a safe distance between the scope body and the shooter's eye. Both the windage and elevation turret caps and the battery compartment covers are sealed with O-rings, and the reticle lighting switch is waterproof.
The overall impression is that it's a well-made and functional scope. Perhaps more importantly, it's a great accessory for those looking for the original Chinese military appearance. The scope's engraved Chinese characters add to the authentic look.

pldg.jpg

bjhd.jpg
 
Last edited:
There was a seller on the EE with a few of these scopes. I really wanted one but the price was very high. I seem to recall in the $700 range.

I plan on keeping mine iron sights for now but would love to add one of those scopes if we can get them at a reasonable price.

How's the glass? Field of view and eye relief? Also how much change is there in eye relief when changing magnification?
 
>Adriel: You're right; the scope is a bit too high to get a decent cheek weld.
>Epoxy7: No idea how to comment on the glass, except to say that it's coated, and has a greenish tint. The end of the rubber eyepiece is 40 mm from the ocular lens, and there's at most another 15 to 20 mm where you can see the full field of view. I wear glasses, and for all practical purposes, I have to bring the eyepiece right up to my glasses. The Chinese documentation mentions that the eyepiece is at the optimal distance from the scope, and it's obviously designed to be placed up against the eye.
The scope's magnification is not adjustable. The field of view is roughly 40 feet at 100 yards (extrapolated from a test at 20 feet).
 
I bought one of the original scopes from Lever arms and kept it when my 97 was reclaimed by the cops. Just bought another one (yes the rifle is now non restricted and cheaper so not all isbad). Scope does match but to be honest its not that great to use. The switch for turning on the reticle is a very 1960s toggle switch. The reticle itself is very fine and difficult to see and the illumination does not help unless in very low light conditions. Field of view and magnification not great.

Overall good if you are in to collecting. Not good if you are into shooting
 
Back
Top Bottom