Prvi/ Yugo Brass 8mm?

[y2k]

Who carries Prvi ( Yugo ) brass in 8mm? Tradex is out

 

[Crazy Chaingun]

If you don't mind once-fired, you might try put a WTB ad in the EE.
Usually lots of brass for sale there.

 

[bjmurata]

You could try RaynerShine Gunworks,they normally have a good selection of components on hand.

 

[polaris]

PRVI brass is good quality, but if you are looking for a steady supply, do like me and make 8mm brass from 30-06 brass which is cheap and plentiful.

BTW Higginson has new Winchester 8mm brass for $33.50/50pcs.

 

[Bassmaster]

PRVI brass is good quality, but if you are looking for a steady supply, do like me and make 8mm brass from 30-06 brass which is cheap and plentiful.

BTW Higginson has new Winchester 8mm brass for $33.50/50pcs.

I did the same, took me about 45 min to make 50 pcs...cut, formed and trimmed. My WTB in EE for 8mm didn't produce much. Mind you I haven't had a chance to try them yet. 30-06 is laying around everywhere where I shoot

 

[bjmurata]

PRVI brass is good quality, but if you are looking for a steady supply, do like me and make 8mm brass from 30-06 brass which is cheap and plentiful.

BTW Higginson has new Winchester 8mm brass for $33.50/50pcs.

The 30-06 is my go to round for a lot of reasons,including the fact that I can form cases for many other numbers from them quite easily,especially this time of year that part of the hobby keeps me pretty much occupied.

 

[Eaglelord17]

Personally looking around, I am just going to wait until its back in stock at tradeex then I am going to order a 500rd case or two because everywhere it has free shipping is sold out and otherwise it gets to expensive.