1.93 mounts for 1 inch scopes?

70m4h4wk

70m4h4wk

CGN Regular
Rating - 100%
22   0   0
Location
Paris of the Prairies
Anyone know where I might find a 1.93" height mount, or better yet, rings that height, for a 1 inch tube scope? The only one I've found is made by LaRue and last I checked they don't sell their products in Canada.

It would also be cool if it didn't cost over $200 but I was ready to drop the $400 or $500 for a scalarworks leap mount before I found out they only come in 30mm and 34mm.

Is this not a thing? Do I have to upgrade my scope to a 30mm tube?
 
You might be able to find some delrin reducers to put around your scope to make the od 30mm. I know I saw some at a vendor before, just can't remember who.
 
I'm not real sure what you are looking for - typical listings, like at Brownells, are showing a ring height - often measured to centre of the ring, from the top of the base. I have seen other maker's list a height dimension from top of base to underside of the scope tube - so that would be .500" difference in listing, for the same height ring - might help you to find what you are looking for??
 
you may be looking at extra high rings mounted on a rail to get that kind of height, I have lots of 30mm to 1 inch reducers if and when required.
I didn't want a rail over my loading port on my rifle so I simple ran an aluminum rail through the bandsaw and painted the fresh cuts with a sharpie after filing smooth. 2 inches is pretty high for a scope, what are you trying to mount it on? I have custom silhouette rings that are 1.5 inch to the bottom of the tube, so 2 inches to the center of the tube, but they mount on a dovetail, check out moore accuracy for silhouette scope ring options as they will fall into your price range and they make centerfire set up options
 
If you aren't desperate to get under a weight limit there are risers available. Look a bit clunky and add more fasteners though.
 
Potashminer said:
I'm not real sure what you are looking for - typical listings, like at Brownells, are showing a ring height - often measured to centre of the ring, from the top of the base. I have seen other maker's list a height dimension from top of base to underside of the scope tube - so that would be .500" difference in listing, for the same height ring - might help you to find what you are looking for??
Click to expand...

The 1.93" measurement is from the top of the rail to the center of the scope ring. It's the nominal measurement for extra high mounts for modern sporting rifles. The tallest I can find for 1 inch scopes so far is 1.5"

yodave said:
you may be looking at extra high rings mounted on a rail to get that kind of height, I have lots of 30mm to 1 inch reducers if and when required.
I didn't want a rail over my loading port on my rifle so I simple ran an aluminum rail through the bandsaw and painted the fresh cuts with a sharpie after filing smooth. 2 inches is pretty high for a scope, what are you trying to mount it on? I have custom silhouette rings that are 1.5 inch to the bottom of the tube, so 2 inches to the center of the tube, but they mount on a dovetail, check out moore accuracy for silhouette scope ring options as they will fall into your price range and they make centerfire set up options
Click to expand...

Thanks for the tip, I'll check out those silhouette rings.

Grantmac said:
If you aren't desperate to get under a weight limit there are risers available. Look a bit clunky and add more fasteners though.
Click to expand...

I'd like to avoid adding more pieces to my stack of rail and rings. With my luck, that's just more things to come loose.
 
You must log in or register to reply here.
Back
Top Bottom