I dug this up while looking for the effect of barrel length vs quality etc...
Does this hold merrit? I am interested in getting a short 12.5 dlask barrel, but only if I retain accuracy over the stock ruger barrel..
What do youguys think?
link: http://www.sniperforums.com/forum/rimfire/38241-22-lr-barrel-length-performance.htmlhad a play at the range today with my 10/22. i am on good terms with the dealer/gunsmith that operates the range and he let me switch out a few barrels with some 10/22s he had in stock (used) and have a play with his chronograph. the same box of cci subs were used exclisivly and an average fps was taken from 5 rounds. all groups are also 5 rounds of cci subs at 55yds. where i have put +mod a .22 sakmod was fitted.
22 inch standard stainless barrel +mod - 957fps .25 inch group.
20 inch standard barrel +mod - 964fps .5 inch group.
18.5 inch standard carbine barrel +mod - 973fps .5 inch group.
16.12 inch standard compact barrel +mod - 986fps .5 inch group.
14 inch Volquartsen fancy carbon fibre barrel - 1008fps .2 inch group.
12.25 inch cut down standard stainless barrel (my barrel) +mod 1002fps .25 inch group.
hope this info helps. i know it would be more usefull if it was the same barrel cut down a bit at a time. i am also confident that if i had used ammo with a higher powder charge the results would have been different.
Does this hold merrit? I am interested in getting a short 12.5 dlask barrel, but only if I retain accuracy over the stock ruger barrel..
What do youguys think?


















































