10 gauge resizing die

ssapach

ssapach

CGN Ultra frequent flyer
Rating - 100%
88   0   0
Location
Alberta
I wonder if anyone here has any info or recommendations on a die for resizing my 10 gauge hulls? Also, any recommendations on where to acquire?

I'm sure I could google all day long, but I'd prefer to hear from anyone who actually has and uses or had and used something that they'd recommend.

I should mention I do not have a press of any kind, as all my reloading is 2-7/8" shells and I reload all by hand so far. So the plus side is I don't have to worry about adapting to anything in particular.

I use 2 different shotguns, and I'm just getting a little tired of having to sort through shells that were fired in one and don't fit in the other. So I figured a proper resizing tool would be best.

Appreciate any input. Thanks in advance!
 
ht tps://www.mecshootingsports.com/p-393-super-sizer.aspx

I use one of these in 12 gauge for my Parker loads and specialty loads for my Beretta and it works very well sizing the bases of either high brass or low brass shells to slip easily into the chamber.
 
The MEC super sizer is the way to go. I use a MEC Sizemaster which has the sizer built in,
I would look at getting a complete used Sizemaster press here for a good deal because finding only the sizer will be difficult task I think.
BB
 
Thanks for the replies. I didn't realize it was going to be narrowed down to one manufacturer so quickly, but the Super Sizer looks pretty slick and simple to use.
 
You must log in or register to reply here.
Back
Top Bottom