100gr bullets for .308? twist rate?

IM_Lugger

CGN Ultra frequent flyer
Rating - 100%
216   0   0
Location
Hamilton
Seems like i can get 100gr-ers for a big less than the heavier stuff but i was wondering if that's a bit on a light side? what twist rate should they be used with? any reason not to use it in a Rem. 700 sps tactical?
 
30br? what is that?

i'll be shooting these at 100 yards mostly so long range shooting is not a problem
:)

i think sps tactical has a 1:9 or 1:12 twist (?) so i'm guessing it would not work?
 
Common logic suggests these are too light for most loads and twists out of a .308 Win.

The 100gr tends to be a .30 Carbine bullet.
 
The 100 grain bullets may shoot accurate enough, in spite of some extra spin. What some have pointed out to you is that 100 grain bullets are too light for a 30 calibre rifle. They would lose speed much too fast to be very practical and the wind may blow them into the next county.
 
They'll work just fine, especially at 100 yards.

Here's everything "wrong" with what you're doing:
- your rifle's twist quite a bit faster than it needs to be
- they're probably not good hunting bullets
- they're probably not match-grade target bullets
- they'll be blown about by the wind more than a 150+ grain bullet (a 10mph wind that blows a 165 grain Hornady Spire point bullet 0.9" sideways at 100 yards, will blow a 100 grain Hornady bullet 2.4" sideways; not a big deal either way, especially since 10mph is a lot more wind than it sounds like!)
- the throat in your rifle is almost certainly "too long", in that you won't be able to load ammo so that your bullet is touching or nearly touching your rifling.

But if none of these is a deal-killer for you, have at it; they'll all safely go "bang", and zip right through whatever target you staple up at 100 yards

(BTW ".30 BR" is a benchrest cartridge, used for short range benchrest shooting for score. Picture a 2/3-length .308 Winchester).
 
Back
Top Bottom