.22 chamber iron

That was one of the first tools I made when I took my gunsmithing course... I think I used it once and decided it is an obsolete procedure.

I much prefer to use a .22 LR chamber reamer to remove the displaced material as the dent left will probably not get any deeper... I have never had any bad results with the reamer.
 
You can make your own with a Number 2 drill bit and a bit of filing and sanding.

Drift out as much as will go quickly, then ream to clean it up, and have the best of both methods.

Cheers
Trev
 
You must log in or register to reply here.
Back
Top Bottom