222 serbian brass primer wont come out
- Thread starter bucktomcat
- Start date
Could be the size of the flash hole. Could be that it's crimped in place, but even that isn't likely to break pins.
If it's Privi Partizan, I haven't reloaded their .223, but I have reloaded their .303 British and it's really good stuff. I'd try checking the flash hole.
If it's Privi Partizan, I haven't reloaded their .223, but I have reloaded their .303 British and it's really good stuff. I'd try checking the flash hole.
bucktomcat
Regular
Drum roll and the winner is ATOM! Flash hole too small or pin too big how ever you look at it!
Thanks for the help
Thanks for the help
- Location
- Somewhere on the Hudson Bay Coast
Small flash holes are a problem I ran into with Gevelot 7X57 brass too; I didn't break any pins that I recall, but it would pull the pin out of the sizing button which got very tedious, very quickly.
I mostly deprime my rifle brass with the Lee tool that come with the Lee Loader kit. I have both the smaller and larger size. I know it is more tedious, but it does give me the opportunity to look over the brass one more time. 
View attachment 12073 View attachment 12074
View attachment 12073 View attachment 12074
- Location
- Saskatchewan
I had that problem with Igman .222 brass. Flash hole is too small. The Lee deprimer looks like a good bet to try, also my dies did not have "headed" decapping pins. I am throwing away what Igman brass I have left. Thanks for the heads up on the Gevelot 7x57 stuff Boomer, I have a couple hundred of those (once fired factory load cases) , and will watch for the problem.
