Just picked up a savage mod 11 in 223 and was gunna start out loading a handfull of rounds to test out but im still a bit of a newbie. I tried to check what i should use for an oal by putting a spent case that i squished a little bit to hold the bullet loosely into the chamber, but when i put it in the chamber and cycle it threw it never touched the lands. would this mean theres excess throat space or should i just go with the 2.260 oal length thats in my nosler book for this caliber? Or is this just because of the im using little 50gr's im having this problem?
I normally do the same steps as above and seat the bullet .010-.015 deeper then measured.
hears what im using
50gr ballistic silver tips(might try something different in the 70gr range next)
federal brass thats once fired in this gun oal 1.40(seams short?)
br-4 primers
starting out with 23gr of varget.
I seated them to 2.3 oal witch is just enough so the bullet is completely seated in the whole neck. From what I understand this should be fine.
Id love some feedback befor i head for the range.
thanks
I normally do the same steps as above and seat the bullet .010-.015 deeper then measured.
hears what im using
50gr ballistic silver tips(might try something different in the 70gr range next)
federal brass thats once fired in this gun oal 1.40(seams short?)
br-4 primers
starting out with 23gr of varget.
I seated them to 2.3 oal witch is just enough so the bullet is completely seated in the whole neck. From what I understand this should be fine.
Id love some feedback befor i head for the range.
thanks


















































