30-06 hunting loads?
- Thread starter Buzz
- Start date
30.06 loads
I tryed some RL 19 last weekend for the first time, in my Rem 700 BDL 22" barrel, I put on a target scope, and did all work on once fired brass, put some RL 19 with 168 gr Speer Gold Match bullets made up 6 batches of 3 shots 1/2 gr apart.
Can,t see why this load would drive a 165gr Nosler,or any good 165 gr bullet for hunting the lowest load was chronied at 2590 fpshttp:/
/
I have just finnished loading 15 with load and going to try them at 300 yards
I have never shot this type of group with a Reg weight hunting gun only my benchrest guns, the only thing done to gun is its Pilar bedded in accuglass and trigger is at 2.5lbs
I tryed some RL 19 last weekend for the first time, in my Rem 700 BDL 22" barrel, I put on a target scope, and did all work on once fired brass, put some RL 19 with 168 gr Speer Gold Match bullets made up 6 batches of 3 shots 1/2 gr apart.
Can,t see why this load would drive a 165gr Nosler,or any good 165 gr bullet for hunting the lowest load was chronied at 2590 fpshttp:/
/I have just finnished loading 15 with load and going to try them at 300 yards
I have never shot this type of group with a Reg weight hunting gun only my benchrest guns, the only thing done to gun is its Pilar bedded in accuglass and trigger is at 2.5lbs
180 Nosler Partition chased by 61 grains of Reloder 22 in a Winchester case with a WLR primer. 2850 in a 24" tube and under 1MOA in three of my rifles. 180 Accubond showed similar results. As per usual warnings start lower and work up safely. Eagleye.
57gr of IMR 4350 and 168gr Hornady A-max. shoots 1/2 inch from a kreiger barreled mauser 98.
watch out at close range, within 100 yards the A-max will leave an 8 inch exit. beyond that they perform same as regular bullets. i have not shot anything besides deer with this load.
watch out at close range, within 100 yards the A-max will leave an 8 inch exit. beyond that they perform same as regular bullets. i have not shot anything besides deer with this load.
I know us Canadians don't take everybody to court, but asking somebody for a favorite load is opening the door to all kinds of legal problems if you use or misuse his data and blow up, or worse hurt yourself with it. Do like everybody else and read a couple of manuals and make some test loads to see what works in YOUR rifle.
Wow, let me just check my hornady, speer, nosler, or Lyman manual.....hmmm..nope no mention in there about safety nazis...but thanks for the advice...
Good advice Iceman 2
I will give out componants that have worked for me to help some one out, but never put down the amount of powder I put in load, and I never shoot anyone elses reloads. Except my brothers.
I know a fellow who sold two beautifull guns, that new owners destroyed using wrong powders. and are very very lucky there was no injuries, reloading is fun, but can be dangerous.
I will give out componants that have worked for me to help some one out, but never put down the amount of powder I put in load, and I never shoot anyone elses reloads. Except my brothers.
I know a fellow who sold two beautifull guns, that new owners destroyed using wrong powders. and are very very lucky there was no injuries, reloading is fun, but can be dangerous.
