.30 Rem info needed

C

Carcaju

BANNED
Member
BANNED
Rating - 89.7%
24   3   2
Location
AB
Howdy Folks! Can anyone give me any loading data for .30Rem? Can you still get dies and brass?

Thank you for your valuable time!
 
Use the 30-30 data as already mentioned, if you are loading for a M14 you will want to do some looking around for the proper COL or they jam up and are fun to clear. Again if it is the M14 you will need to use Roundnose bullets to get the feeding and COL to work properly. One of these two forums may be of some help as there is a small but experienced following there:
http://vintagesemiautorifle.proboards.com/index.cgi
http://thegreatmodel8.remingtonsociety.com/forums/

Talk to Henry at Budget Shooting supply for brass. Reeds Ammo has it but they no longer ship up here, maybe they would thru Him.
 
I don't want to hijack the thread, but I have an old Remmy pump in .25 Rem. I understand I can use .30 Rem brass.
I would also welcome suggestions for dies, brass, and reloading--I would love to bring this old girl 'back to life'.

Thanks
Therion
 
Put up a WTB for the dies here, thats how I got my 25s. They aren't cheap tho! Unless you want to drive up here and use mine.
I have used the 30 Rem brass and necked it down. Hornady 117gr RN are your best bet for a bullet.
As to the rest fire me a PM and I can offer what I've found to work for load data. I hate to get off course here.:p
 
According to the Handloader's Manual of Cartridge Conversions you can make .30 Remington cases from .30-30's or .225 Winchester cases but you need a lathe to do it.

If you can find any .25 Remington cases you could neck them up.
 
You must log in or register to reply here.
Back
Top Bottom