300 wsm or 6.5 prc for moose hunt?

jzerebeski86

New member
Rating - 0%
0   0   0
I’m gearing up to go on a moose and deer hunt in a couple weeks, and can’t decide whether I should use my 300 wsm or 6.5 prc. Any thoughts/advise would be greatly appreciated.
 
300, just because.

U had this very debate with myself last week between a model 70 300 win mag or 45-70 guide gun.

Settled on the guide gun based on terrain, shooting distance and size of gun.
 
Ive been asking myself this question alot and i decided to have both in a switch barrel setup of a Defiance XM+. 6.5 PRC seem to fit fine in the SA configuration with 140s range bullets but the WSM need longer space for the 200s. To be continued...
 
I’m gearing up to go on a moose and deer hunt in a couple weeks, and can’t decide whether I should use my 300 wsm or 6.5 prc. Any thoughts/advise would be greatly appreciated.

My 1st choice would be the short mag (heaver/slower bullets may give you an advantage at short ranges), but either will work just fine. The Moose won't be any less dead if you hit it in the vitals.
 
My dilemma was my custom 6.5 PRC that is pushing the 156 gr berger tips, that I practice with out to 1000 m, or my newly aquired ruger #1 in 450 BM that I practice with out to 350m. Yes the areas I sometimes hunt can and do present themselves with longer shots, and depending on current site conditions I have to make the call to shoot or not. I'll just leave it at that.

Well the 6.5 sat in camp all week and was playing my back up if need be. Didn't even get to see daylight, besides at the beginning of the trip when I opened the case to remove the other rifle that was travelling with it.

I exclusively carried my 450 BM, and got to use it a few times on my last trip. That will be for another story though.

It now gets the nod on my next trip, leaving tomorrow. It is now my newest love! The custom 6.5 will sit in camp as a back up again. Too boot, some freshly loaded 290gr solid copper tips.

Of the two you listed, the one that you can shoot comfortably with out to the ranges you will need, and the one that you can follow up quickly with a 2nd and if need 3rd shot. I specifically practice this at the range, especially now using a single shot, and well let me just say this, it pays off when you really need it and have no time to think and just react. not much different with a bolt action as well, and not too many actually practice this when they can.

Really, the moose will not know the difference of what hit them, if you hit them right!
 
Of all the moose I’ve taken, smallest caliber was a 6.5 prc, and was the longest expiry time I’ve witnessed (140gr accubond @ 50 yards centre lung 2+ minutes to expire). It worked, but I wouldn’t do it again personally. Perhaps a different bullet might have done it quicker.
 
The bullet choice would me more important than the headstamp in my mind. Both will work. Both have suitable bullets and both have bullets that have better alternatives
My choice personally is bigger bullets for bigger animals
 
  • Like
Reactions: DGY
Took an Elk with a 140 grain bullet out of a 6.5 PRC last year. 380 yard lung shot. Required a follow up shot. It was flying at a little over 2900fps out of the muzzle. This year I’m using a 300 wsm, 175 grain LRX. Load development in progress but I’m seeing a lot of promise at 3045 feet per second with that bullet. This will hammer beyond 500 yards.
 
Back
Top Bottom