32 winchester special mold

[hound2013]

does anyone make a mold for 32 win spl lever 94 im looking to make some cast bullets have you got some ideas for me thanks >>>>> hound13

 

[Spawn-Inc]

you can get a custom or pick from the catalogue at accurate molds.

 

[glycerin]

Lyman used to make a mold(321297?)RN about 170gn.

 

[BMcK]

RCBS makes a good mold

 

[oopsmissedagain]

After reading the book by Veral Smith, I bought his mold for 32 winchester special. "LBT molds".
Slug your bore and slug your chamber first. I found many of the "production" company molds were too small in diameter for my gun with cast bullets. That being said, I would go custom from Accurate, LBT, Mountain molds, etc. Mine is .323 diameter. Ya I paid a premium, but I can't stand spending money on stuff that doesn't work the first time. There are enough challenges from what I have read. I am new to this and am looking for success, not headaches.

 

[Paul Barber]

The RCBS mould is excleent , also works well in .32/40

 

[ken fowler]

easy done .get a 8mm gas check mold and size it down to .321. In my gun they will print 1.5 in. at 100 yd.. with line type they are hard to size but hard as jacketed

 

[oopsmissedagain]

are you planning to hunt with cast, or just plink? What velocity are you looking for?

 

[jethunter]

I use a gas checked mold that I got from Accurate Molds. I ordered .324 and size to .323 or .322. 8mm gas checks from Sage's Outdoors work well on them.