so once again my love of obscure calibers in old rifles has cost me money, i impulse purchased this week a BSA 1923 Commercial Sporter in 33 BSA HV. i'd never heard of the cartridge but as i suspected it uses a .333 diameter bullet. i wasnt particularily worried as i knew woodleigh makes them, until i saw the threads about las decembers fire. hawk bullets out of new jersey makes some, and very reasonable price too but an inquiry about canadian sales has gone un answered. so is there anyone else that makes them? and also is this cartridge found in quickload? my computer died and i cant access mine.
333 diameter bullets?
- Thread starter kevin.303
- Start date
vagrantviking
CGN Ultra frequent flyer
- Location
- High River, Alberta
Slug the bore, chamber/throat casting, gauge pins or whatever method you think most accurate instead of guessing. Once you know the size it will be easier to narrow down what you need.
My fallback for very odd sized diameter bullets is a custom mold to cast and size lead bullets but if 33 BSA HV refers to high velocity you probably want to stay with jacketed.
My fallback for very odd sized diameter bullets is a custom mold to cast and size lead bullets but if 33 BSA HV refers to high velocity you probably want to stay with jacketed.
Last edited:
That will work. Woodleigh and Barnes (in their original line) both used to make 33 cal bullets. So did Winchester, but that was a very long time ago. - dan
The 333 OKH. That was developed using english bullets originally intended for the 33 bsa and 333 jefferies. Corbin makes the die to swage down to the proper diameter, just not sure yet if i wanna commit to the cost as how much will i actually shoot it. Will have to wait till it arrives, slug it inspect see how it shoots with cast or if i can find some woodlieghs and go from there
fingers284
CGN Ultra frequent flyer
- Location
- Alberta Cowboy Ranges
Or there is the option for you to take .323 cast slugs & powder coat up to .333 and shoot as jacketed slugs...will be the most inexpensive route i'm thinking.
- Location
- Western Manitoba
As per Posts #2 and #5 - probably need to slug that bore - find out what that one's groove size is, and make or buy bullets to fit that groove size or close. Is not likely based on the bore size - the hole drilled before rifling was cut - typically need to know the groove size, to select or make jacketed bullets ...
I wonder if you look at a 30-30 die it is .330 at the neck. Could one remove the guts and use it as a sizing die for .338 bullets? A shell holder with an appropriate sized extension rod welded on to push a lubed bullet through the die.There may be jacket spring back ? It could be opened up if needed a little.
well look at that. you are indeed correct. i just assumed given its age and place of origin that it would be .333. i will of course still slug the bore just to be sure but if so that makes life far easier.
vagrantviking
CGN Ultra frequent flyer
- Location
- High River, Alberta
Hopefully it takes 338 bullets. It's nice to have something exotic but doesn't have to be too many levels of difficult.
David Henry
CGN Regular
- Location
- West of the big road
If you are in a tight spot for 333 bullets I have a box or maybe a part box of Speer 333 bullets. Sold the OKH years ago, and went with a 338-06 no regrets. D.H.
I'm one of those guys. You could buy a custom 0.333" (or 0.332" like I did, as sized jacketed bullets tend to "spring-back") Lee-style push-through sizer, or you could ream out the stock Lee 0.329". A "Q" drill (0.332") might work or a dowel with emery paper.
