BC Bigbore
CGN frequent flyer
- Location
- BC's Peace Country
Anyone know where I can locate a source for properly headstamped brass for the .338-06 A-Square other than the Weatherby factory loads?
.338-06 A-Square
- Thread starter BC Bigbore
- Start date
Didn't Federal run some of this off a while ago? - dan
BC - Just talked with an actually decent fellow behind the counter at Wholesale a couple days ago. He said that he's never seen the Weatherby stuff come as loaded rounds just unprimed brass. It comes in a regular looking box that says 338-06 Weatherby Magnum but when you look it is unprimed brass. It is not overly cheap though, about $36.00 a box. I bought his only 3 boxes. I'm assuming you did'nt want the Weatherby stuff because it was loaded but you may want to check it out because you can get it unprimed. To be honest I have been looking for 338-06 brass since spring in a lot of places and this was the first I have found. I was about to build it from 06 brass until I found this.
Mighty Peace
CGN frequent flyer
- Location
- Land of the Mighty Peace
Bought 3 boxes of new brass at, heaven forbid me , at Wholesale Sports in Calgary in July. They had 9 boxes at that time. I wanted them for my 338-06AI being built @ Corlanes right now. Even picked up some 225gr Accubonds and TTSX to try for reloads. $35 a bx of 20 rings a bell.
