.338 RUM brass??

Nosler is the only major manufacturer offering 338 RUM at the moment. Expect to shell out $4-5 a piece for a casing, if you can find some.
 
I did find some Nosler at $104/25. That is nuts. Gunna keep looking for now. Remington Canada said that they are not even offering it as a component any longer.
 
Hopefully ITAR gets flushed down the tubes, and components, particularly unusual stuff, from south of the border will be more readily available. BTW, I've reformed some 300 RUM to 338. In case you're wondering, I found some once fired 300RUM for this. Not a trivial task: the body is (IIRC 0.090") shorter than 300 RUM, so sizing is a pain.
 
OldDude said:
Hopefully ITAR gets flushed down the tubes, and components, particularly unusual stuff, from south of the border will be more readily available. BTW, I've reformed some 300 RUM to 338. In case you're wondering, I found some once fired 300RUM for this. Not a trivial task: the body is (IIRC 0.090") shorter than 300 RUM, so sizing is a pain.
Click to expand...

I was wondering about doing that, but it may be a bit above my pay grade. Tempted to get it rechambered to .338 Edge as resizing the brass would be much easier.
 
You must log in or register to reply here.
Back
Top Bottom