34mm rings height question

MartyK2500

CGN Ultra frequent flyer
Rating - 100%
278   0   0
Location
Quebec
Hi guys, i want to order 34mm ATRS rings.
Wondering if you know what height i need, or if i should wait for chassis and scope to arrive to manually figure it out?
Just don't want to end up too low and see part of hanguard in lower portion of scope

Savage 10TR, ATRS 20moa steel rail, MDT ESS chassis with round handguard (no rail on top), Vortex Razor gen ll 4.5-27x56

Thanks!

Setup will be like top rifle in drawing, without rail
 
Last edited:
I would recommend waiting to receive the chassis, or playing it safe and going with a higher than minimum.
chassis-ess.jpg


You can see in this picture that while the top of the chassis isn't in the way, there are still 'wings' that go up on either side and those may contact your scope. We haven't had one in the shop yet for me to confidently provide you a size.
 
NVM: Just realize you don't have the chassis, thought you were only waiting for scope.

The vortex page has the full dimensions of the RazorII scope. Place a 48" level over your scope rails extended to the muzzle. Measure the minimum clearance. Based on 34mm tube calculate the minimum saddle height.

http://www.vortexoptics.com/product...6-riflescope-with-ebr-2c-mrad-reticle/reticle

dim_rzr_g2_ffp.jpg


LENGTHS
L1 L2 L3 L4 L5 L6
14.4 2.0 2.2 6.1 4.1 4.1

HEIGHTS
H1 H2
2.55 1.81
Dimensions measured in inches.
 
Back
Top Bottom