375 Ruger
- Thread starter todbartell
- Start date
Might be a BIT hard to chamber it !RJ
how so? 375 Ruger body diameter is as wide as a belt on a 300wm, just have to trim back to 2.58"
Actually in the fireforming it shrinks back so no trimming required...........and a factory 300 WM headspaces perfectly !!!! Literally you can just throw a factory 300 WM in the chamber and pull the trigger and out comes a perfectly formed 375 Ruger. Another 4 or 5 loads and the belt all but disappears.
Mag capacity is listed as 3 on line.
Just sayin'.
Since the H&H belt is the same diameter as the ruger body, shouldn't it be the same?
The Ruger RSM holds 4 H&H....... The CZ holds 5 H&H....... haven't seen a rifle chambered in 375 ruger that holds more than 3.....
Not that it would be a huge deal breaker for me.....
Ardent
CGN Ultra frequent flyer
You are confusing "mag capacity" with "different rifles"
Take the CZ out of the equation then.... look only at M77 variants.... All of the M77 375 H&H rifles hold 4, and all of the M77 375 Ruger rifles hold 3.....
The RSM is a true magnum sized action. It is not the same rifle as the one used for the 375 Ruger.
To further explain - the Ruger rifles with HH based cartridges (like 300 WM) also only hold 3 in the magazine.
What does that have to do with magazine capacity?
