38 S+W brass in 9mm revolver
- Thread starter MiG25
- Start date
I forgot that some revolvers are meant to work without clips. These might not have room for rims.
Best is to make a search gun by gun and ask around. I know a shooter who has a big S&W 8(?) shots in 9 Luger. If he hasn't given up on current restrictions like me I might see the gun next month.
Gunblast has usually clear pictures of cylinders back ends in their articles.
Ed Harris wrote about doing what you want, but I cannot find the article/post.
Last edited:
Is that safe to shoot 9mm out of a webly/enfield long term? I avoid buying one because of the cost of ammo but if 9mm works I would go buy one. I imagine accuracy is bad but I would not really care. Is 9mm even practical to use in a 38S&W?
9mm is a 35,000 psi round
38 S&W is more like 15,000 psi
It will fire ok, but the gun will be damaged if you keep at it. A cheap gun might blow up.
If you re-load, you can use 9mm brass to make plinking ammo for the 38S&W, IF your 38 chamber has a shoulder in it to hold the 9mm case on the case mouth.
Last edited:
If you did use 38 S&W brass you would have to make sure you use 9mm dies as 38 S&W dies are going to swage the brass larger by about .003". On that note the stress of squeezing down the brass more than was meant might fatigue it sooner. Trimmed down 38 Special brass might work better.
Cheers
Moe
Cheers
Moe
Many years ago Federal ammo and Ruger firearms were working on building a rimmed version of the 9mm for use in a revolver. The project was scrapped when the scenario you've described presented itself. The common thought was the some shooters would foolishly use the high pressure ammo in a firearm designed for low pressure ammo.
Don't know about all brands but a buddy with a 38S&W revolver gave me a few to check in my Alfa Project 9mm revolver. They worked fine. Bought 100 38S&W brass and used them now and then in that revolver with out the need to use the moonclips. Yes, they had to be slightly trimmed. And I used 9mm dies to reload them. Just had to alter the sizing die to avoid stopping hard on the rim.
The spacing of the head stamps and primers off the back surface of the cylinder was slightly greater than 9mm with moonclips. But it was close enough that the 38 S&W still worked fine. At least on the AP revolver. Can't say about any others.
The spacing of the head stamps and primers off the back surface of the cylinder was slightly greater than 9mm with moonclips. But it was close enough that the 38 S&W still worked fine. At least on the AP revolver. Can't say about any others.
