45 LC Reload help for Cowboy shooting

fatbastard

Regular
Rating - 100%
23   0   0
Ok here it is.

I am just getting into Cowboy shooting and need some info on reloads for 45 LC.

What bullet wieght do most use and what are the advantages.
What powder?
I have Starline brass.


Thanks
Don
 
Depends on what you can get for powder. I use a 250g LRNFP on top of 5g of Ramshot Competition and results are xlnt.
dB
 
HOWDY; Starline is stiff brass so a 250 may be the best to help seal the case from blowback. I and others use 200 in revolvers but if you have a marlin rifle 200s will give blow back over the bolt into your eye. SO I end up with schofield length brass 200s in revolver and 250s in colt cases for the rifle.
 
Just as a caution, my Ruger Blackhawk 4 5/8" barrel chrono's at 840 fps with Wolf reloads. He used a weighed 6.3gr of W-231 with the 250gr RNFP

mine's DIRECTLY from the WINCHESTER manual- and a 7.5 inch barrel -13000 fps pressure- that's THEIR factory load- maybe your chrono's off a bit?
 
Titegroup 5.6 GRAINS 250 grain RNFP...Rifle and Revolver ..very accurate. Check Hodgdon

Don't rule out UNIQUE......Trail Boss will give you light loads.
 
I prefer to use 250 grain bullets, as I feel that if I am going to shoot a .45 Colt, then I might as well act like it. I know that some are shooting 200 grain, or even lighter, and loads that barely dribble out of the barrel. Again, I prefer to have at least 750 fps, and I get that with Red Dot as my favourite.
 
5.5 gr Trail Boss driving a 350 gr bullet for me.
I like the way TB fills the case.
Easier for these old eyes to check for doubles etc.
 
Back
Top Bottom