590 safety not functioning.

[st1264]

You get this issue worked out?

 

[EL34/6L6]

No, time hasnt been on my side the last 4-5 days.

 

[Greenhorse six]

If screw on the safety is not tightened enough or the safety block isn't seated properly this can cause it to interfere with the connector [ protruding metal piece on the trigger assembly .] and not engage .
The wear on the safety block is from the connector , this is normal , that's where the 2 come in contact and block the trigger , but it's so tight that it wouldn't take much to hang it up .

 

[EL34/6L6]

Thanks, ↑↑↑ I'll look at the whole safety install again.

It was fine, then I took it out and after a few boxes of shells it started acting up and hasn't been the same since.